Kitchen assembly and assembly services for nobilia kitchens - TOP-SHELF.de


Which services are included in the kitchen assembly?

  • Delivery and contracting to the purpose / location
  • Installation and connection of all electrical devices included in the scope of delivery
  • Connection of cold / hot water
  • Installation and connection of the dishwasher (if provided in the kitchen), inlet and outlet hose in standard length are included in the scope of delivery of the kitchen
  • Assembly of kitchen furniture including wall fixings (not possible with plasterboard walls less than 25 mm thick)
  • Installation of wall end profiles, plinth panels and niche cladding
  • Worktop cut-outs for hobs and sinks
  • Installation of the hotplate / glass ceramic hob
  • Cooker and hob / glass ceramic hob connection
  • Installation of extractor hoods (including recirculation set if available)
  • Installation of work lighting
  • Assembly, extension and connection of sinks, mixer taps and siphons (the kitchen does not include a siphon or fitting, please provide these for installation)
  • Adaptation of the plinth panels
  • Notching of cabinet parts as long as the statics of the body are not impaired
  • Use of ALU sealing tape on open cut edges of wooden parts
  • Reductions / adjustments to countertops (except stone / acrylic)
  • Joint final acceptance and functional test of the fully assembled kitchen including the electrical appliances with the customer (customer confirms acceptance with signature on the delivery note; if necessary, documentation of deviations)

Please note the following:

  • The delivery time of the kitchen may vary extend, there Delivery and assembly at the the same day be performed.
  • the length and depth the room must be sufficient to accommodate the kitchen to assemble completely. When measuring, please pay attention to possible sloping ceilings, pipes or similar devices that could hinder the kitchen installation.
  • The water connections and drainage pipes must be in the correct position to enable connection of the sink or a dishwasher. The angle valve intended for connection to the water network must be suitable and intact. Connection to low-pressure devices (boiler, instantaneous water heater) is not possible.
  • Power connections, sockets and water connections must be available and should not be located directly behind the devices.
  • To connect the electric cooker, connections must be available that comply with VDE regulations and are no more than 1.20 m away from the device.
  • Changes to stainless steel products (e.g. shortening chimney hood shafts), connecting used devices to the electricity / water network and connecting gas hobs / stoves is not possible.
  • Glass processing (e.g. niche cladding) cannot be carried out.
-

-